Lead4pass Cisco 200-155 dumps exam questions answers are updated (85 Q&As) are verified by experts. The associated certifications of Cisco dumps is Cisco CCNA Data Center. Become a Cisco troubleshooting ninja! This study guide is the first in a six course series covering the Cisco CCNA Data Center https://www.leads4pass.com/200-155.html dumps exam.
What are the best study tools for the Cisco 200-155 dumps? “Introducing Cisco Data Center Technologies” is the name of Cisco 200-155 exam dumps which covers all the knowledge points of the real Cisco exam. Useful Cisco 200-155 dumps pdf Cisco exam new questions video training guaranteed success.
Download free latest Cisco 200-155 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VROUdnZWRYLTJta1E
Download free latest Cisco 300-170 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRTTN5QTAtSzJBTWc
Vendor: Cisco
Certifications: CCNA Data Center
Exam Name: Introducing Cisco Data Center Technologies
Exam Code: 200-155
Total Questions: 85 Q&As
QUESTION 1
A switch is configured with all ports assigned to VLAN 2 with full duplex FastEthernet to segment existing departmental traffic.
What is the effect of adding switch ports to a new VLAN on the switch?
A. More collision domains will be created.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
Correct Answer: D
QUESTION 2
Which two commands can be used to verify a trunk link configuration status on a given Cisco switch interface? (Choose two.)
A. show interface trunk
B. show interface interface
C. show ip interface brief
D. show interface vlan
E. show interface switchport
Correct Answer: AE
QUESTION 3
A dynamically routed private line and a statically routed IPsec tunnel connect two offices. What routing configuration prefers the IPsec tunnel only in the event of a private line failure?
A. floating static entry
B. EIGRP variance
C. bandwidth metric
D. OSPF maximum paths
Correct Answer: A
QUESTION 4
200-155 dumps What must be done for Cisco WLC and Cisco WCS to communicate?
A. The IP address and subnet mask of the Cisco WLC must be configured in the Cisco WCS.
B. The IP address and subnet mask of the Cisco WCS must be configured in the Cisco WLC.
C. The identity certificate of the Cisco WLC must be added to the Cisco WCS.
D. The Cisco WLC and Cisco WCS must exchange identity certificates.
Correct Answer: A
QUESTION 5
Which architecture is used to divide the roles between the access point and the WLC when deploying a centralized wireless solution?
A. Split MAC
B. CAPWAP
C. LWAPP
D. Local MAC
Correct Answer: A
QUESTION 6
A network engineer requires that an OSPF ASBR must only flood external LSAs only within its own area. What OSPF area type should be configured?
A. Backbone Area
B. Totally Stub Area
C. Not So Stubby Area
D. Stub Area
Correct Answer: C
QUESTION 7
Which two of these are characteristics of the 802.1Q protocol? (Choose two.)
A. It is used exclusively for tagging VLAN frames and does not address network reconvergence following switched network topology changes.
B. It modifies the 802.3 frame header, and thus requires that the FCS be recomputed.
C. It is a Layer 2 messaging protocol which maintains VLAN configurations across networks.
D. It includes an 8-bit field which specifies the priority of a frame.
E. It is a trunking protocol capable of carrying untagged frames.
Correct Answer: BE
QUESTION 8
During the deployment of a wireless network for data and location services, an engineer is to fine-tune the location services.
What is this type of survey called?
A. passive fingerprinting
B. passive calibrating
C. active fingerprinting
D. active calibrating
Correct Answer: A
QUESTION 9
You want to gather as much detail as possible during a network audit, to include data time stamping across a large number of interfaces, customized according to interface, with a minimal impact on the network devices themselves. 200-155 dumps
Which tool would you use to meet these requirements?
A. RMON
B. SNMPv3
C. NetFlow
D. Cisco Discovery Protocol
Correct Answer: C
QUESTION 10
Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?
A. ping address
B. tracert address
C. traceroute address
D. arp address
Correct Answer: A
QUESTION 11
Which statement is true concerning the data center access layer design?
A. The access layer in the data center is typically built at Layer 3, which allows for better sharing of services across multiple servers.
B. With Layer 2 access, the default gateway for the servers can be configured at the access or aggregation layer.
C. A dual-homing NIC requires a VLAN or trunk between the two access switches to support the dual IP addresses on the two server links to two separate switches.
D. The access layer is normally not required, as dual homing is standard from the servers to the aggregation layer.
Correct Answer: B
QUESTION 12
Which statement about VLAN operation on Cisco Catalyst switches is true?
A. When a packet is received from an 802.1Q trunk, the VLAN ID can be determined from the source MAC address and the MAC address table.
B. Unknown unicast frames are retransmitted only to the ports that belong to the same VLAN.
C. Broadcast and multicast frames are retransmitted to ports that are configured on different VLAN.
D. Ports between switches should be configured in access mode so that VLANs can span across the ports.
Correct Answer: B
Reference: https://www.leads4pass.com/200-155.html dumps exam practice materials and study guides update free try, 100% success and guarantee to pass.
Watch the video to learn more: https://youtu.be/MHDYkPVUMBQ